approximately 2 to 4 weeksLCA-2 LinkControl is an adapter with USB interface for connecting your microsonic sensors to a PC or Laptop. With the supplied LinkControl software, which is also free to download, the parameters of the ultrasonic sensors of the mic-, mic+, hps+, crm+ series can be configured in Windows®.
Configuration screen sensors with an analog output
Below you can see how analog sensors can be set via the software.
The current measured values of the ultrasonic sensors can be graphically represented in the LinkControl software. There are three different graphs available for this. The “LinkCopy” function allows a download of the sensor parameters from the sensor in the LCA-2 and then the upload of these parameters into another sensor. This makes it very convenient to copy sensor settings from one sensor to another. The offline programming within LinkCopy. With some sensor families, the sensor settings copied to the LCA-2 can be displayed and edited directly on the digital display before being written back into a sensor. For the “LinkCopy” function, the LinkControl adapter must not be connected to a PC.
Configuration screen for sensors with a digital switching output
The following shows how digital sensors with a switching output can be set up through the software.
The LCA-2 reads the parameters from the sensor and stores them internally in an EEPROM. The data is therefore retained in the LinkControl Adapter even after the supply voltage has been switched off and can therefore also be used as an archive for the sensor setting. With the built-in TeachBox, all ultrasonic sensors can be conveniently set, which are taught to the sensor plug by means of pin 5 (mic, pico +, lpc, lcs, esf series). The LinkControl adapter LCA-2 is integrated between the sensor connection cable and the sensor, a PC or laptop is not necessary. With the “Teach-in” procedure using the two buttons T1 and T2, the display shows the length of the button press in seconds.
In stock
