Shopping Cart

No products in the cart.


406,60 excl. VAT

mic+130/DIU/TC from microsonic

The mic+130/DIU/TC is an ultrasonic sensor in M30 housing with LED display and a range of 200 to 2,000 mm, 1 x PNP switching output and an analog 4-20 mA / 0-10 Vdc output.

In stock
HS Code: 85365019Country of Origin: Germany SKU: 10040154 Categories: ,
Guaranteed Safe Checkout


With TouchControl all settings of the sensors can be adjusted. The easy-to-read 3-digit LED display continuously shows the currently measured distance and automatically switches between display in mm and cm. Below the display there are two buttons that help set the sensor and cycle through the menu. The switching points of the switching outputs and the window of the analog output can be set numerically using the display. The object to be detected does not have to be present to set the outputs. This makes it possible to teach the sensor without being present at the application location or using a reflector.


LinkControl consists of the LinkControl adapter and added software that allow the mic+ sensors to be set-up through a PC or laptop with the Windows® operating system. All settings in the TouchControl menu can be read, edited via the PC or laptop, saved and sent back to the sensor - all during the operation of the sensor. The two measurement displays offer a solution in complex automation applications by visualizing the distance values.


In an application with up to ten sensors operating in the same room, the synchronization and multiplexing are automatically provided by the sensors. The sensor with the largest measuring range determines the switching frequency of the entire measurement. The synchronization is active when the sensors are electrically connected via pin 5 of the round M12 connector. All sensors measure synchronously at the same time. When mounted equally spaced, the sensors can receive each other's echo signals. This can be used, for example, to extend the measuring range of a sensor. If more than 10 sensors need to be synchronized, a SyncBox 1 can be used.

In multiplex configuration, each sensor only receives its own echo signal. This completely prevents mutual interference. To achieve this, each sensor is assigned its own number from 1 to 10 in the configuration menu. The sensors then operate in multiplex mode and measurements are taken in ascending order of the assigned numbers.


5-pin M12 connector



Sealing class


COM input, Push button (s), LED display, Link control, Multiplex, Synchronization, Temperature compensation



Measuring range

200 - 2,000 mm

Response time

92 ms

Switching frequency

8 Hz




0 - 10 V, 4 - 20 mA, PNP (NC), PNP (NO)


Distance sensor

Power supply

9 - 30 Vdc

You may also like…

  • Connection cables from Murr Elektronik

    PVC 5-wire M12 connection cable

    approximately 2 to 4 weeks

    PVC connection cable for sensors with a 5-pin M12 male connector. The cable is equipped with a 5-pole M12 female connector and makes for a waterproof (IP67) sealing.

    18,3051,30 excl. VAT Select options
  • BF-30-02

    In stock

    Mounting and configuration for Ø 30mm/M30 sensors. Complete with bolts, rings and nuts.  

    14,50 excl. VAT Add to cart
  • BF-30-04

    approximately 2 to 4 weeks

    Right-angled mounting bracket for M30 sensors in 304 stainless steel.

    11,75 excl. VAT Add to cart
  • Connection cables from Murr Elektronik

    PUR 5-wire M12 Connection cable

    On request

    PUR connection cable for sensors with a 5-pin M12 male connector. The cable is equipped with a 5-pole M12 female connector and makes for a waterproof (IP67) sealing.

Our specialists are glad to help

Call directly (working days between 08.30 and 17.00 GMT+1)

Ask your question directly