€301,30 excl. VAT
mic+600/DD/TC is an ultrasonic sensor in M30 housing with LED display and a range from 600 to 8,000 mm, 2 x PNP output and IO-Link interface.
The mic+600/DD/TC ultrasonic sensors from microsonic for level measurements with 2x PNP switching output in an M30 housing has a measuring range from 600 up to 8.000 mm. Depending on the measurement distance the resolution of the sensor has a resolution between 0.025 and 4.2 mm. The mic+600/DD/TC is also equipped with temperature compensation.
With TouchControl all settings of the sensors can be adjusted. The easy-to-read 3-digit LED display continuously shows the currently measured distance and automatically switches between display in mm and cm. Below the display there are two buttons that help set the sensor and cycle through the menu. The switching points of the switching outputs and the window of the analog output can be set numerically using the display. The object to be detected does not have to be present to set the outputs. This makes it possible to teach the sensor without being present at the application location or using a reflector.
LinkControl consists of the LinkControl adapter and associated software that allow the mic+ sensors to be set up with a PC or laptop via the Windows® operating system. All settings in the TouchControl menu can be read out while the sensor is operating and edited via the PC or laptop, saved (intermediately) and sent back to the sensor. In particular, by visualizing distance values, the two measurement displays offer a solution in complex applications within automation.
In an application with up to ten sensors operating in the same room, the synchronization and multiplexing are automatically provided by the sensors. The sensor with the largest measuring range determines the switching frequency of the entire measurement. The synchronization is active when the sensors are electrically connected via pin 5 of the round M12 connector. All sensors measure synchronously at the same time. When mounted equally spaced, the sensors can receive each other's echo signals. This can be used, for example, to extend the measuring range of a sensor. If more than 10 sensors need to be synchronized, a SyncBox 1 can be used.
In multiplex configuration, each sensor only receives its own echo signal. This completely prevents mutual interference. To achieve this, each sensor is assigned its own number from 1 to 10 in the configuration menu. The sensors then operate in multiplex mode and measurements are taken in ascending order of the assigned numbers.
5-pin M12 connector
COM input, Push button (s), LED display, Link control, Multiplex, Synchronization, Temperature compensation
600 - 8,000 mm
NC, NO, PNP
|Amount of outputs|
9 - 30 Vdc
Our specialists will be happy to help you!
Personal advice on mic+600/DD/TC?
Not sure if this product is right for your purpose? Do you still have a question? Our specialists will be happy to help you.